4.1 How To Use The Triggerbot Td2 | Complete

: Ensure all flight controls (yoke, throttle, pedals) are connected via USB before launching the software.

This device is a digital delay controller used for electrical triggering.

: For industrial models, ensure the "HEATER" control is set based on your application (e.g., flow vs. level) to prevent sensor damage. 4.1 How to use the Triggerbot TD2

: Hold the SET button for about 2 seconds to enter mode selection.

To provide more specific instructions, are you setting up a , an industrial flow switch , or a digital cycle timer ? TD/TD2 User Guide - Redbird Help Center : Ensure all flight controls (yoke, throttle, pedals)

: If using the TD I-Series for eye-gaze tracking, enable Overlays Mode in the settings menu.

is a desktop flight training device often used in flight schools. level) to prevent sensor damage

To use the , you generally need to configure its operational mode and parameters using the on-board interface or a software-linked controller. Depending on whether you are referring to a cycle timer or a flight simulator setup, the steps vary significantly. For the ZK-KTD2 Trigger Cycle Timer Go to product viewer dialog for this item.