Ajb0003 | Mp4

The degree of slant added to the wall (typically 0.5° to 5°+ depending on material/finish).

The direction the mold opens, defining whether the draft goes inward or outward. Key Drafting Methods Ajb0003 mp4

You can apply drafts to multiple faces at once, reverse the direction, or change the angle after the part is modeled. The degree of slant added to the wall (typically 0

You can add a taper angle directly inside the Extruded Boss/Base feature rather than as a separate, later step. Advantages and Best Practices You can add a taper angle directly inside

What (SolidWorks, Onshape, Inventor) are you using?

Used for more complex, split-mold designs. It requires a defined parting line (a line, edge, or curve) to draft upward and downward, often allowing for more control over complex contours.

Are you dealing with a (a line dividing two halves of a mold)? Is the part a simple block or a complex curved surface ?