Bfvanilla.zip Link

: Sew a "bar tack" (a wide zigzag stitch in place) across the teeth at the bottom end.

: If your project is longer than your available tape, do not sew two tapes end-to-end; it is better to buy a single continuous zipper roll to maintain structural integrity. 💡 Troubleshooting Common Issues BFVanilla.zip

: If the slider goes on crooked, one side will have "extra" tape at the end. Pull it off and try again to ensure the teeth are perfectly synced. : Sew a "bar tack" (a wide zigzag

: You can crimp on metal top stops or simply sew several loops of thread over the last few teeth on each side. Pull it off and try again to ensure

Since you are creating a custom long piece, you must secure the ends to prevent the slider from flying off:

: Slide the right side into the mouth at a slight angle.