Harmadik.pkt Official

The goal is to establish connectivity between two or more local area networks (LANs) using a router, implementing proper IP addressing, and configuring basic network services. A standard setup for this lab usually includes: Router: 1x Cisco 2911 or 1941 router. Switches: 2x Cisco 2960 switches.

The first packet might time out due to ARP, but subsequent replies should be successful.

Below is a generalized write-up for a typical "Harmadik" (Third) Packet Tracer lab based on common curriculum standards. harmadik.pkt

Ensure all connection dots in Packet Tracer are green.

The file (Hungarian for "third.pkt") is typically a Cisco Packet Tracer laboratory exercise used in Hungarian vocational or university networking courses. While the specific requirements vary by school, these labs generally focus on implementing basic routing, switching, and endpoint configuration. The goal is to establish connectivity between two

Open the Command Prompt on PC0 and ping PC1 : ping 192.168.2.10

Enter the IP, Subnet Mask, and Default Gateway as specified in the table. Repeat for using its respective subnet values. 4. Verification The first packet might time out due to

Router> enable Router# configure terminal Router(config)# interface gigabitEthernet 0/0 Router(config-if)# ip address 192.168.1.1 255.255.255.0 Router(config-if)# no shutdown Router(config-if)# exit Router(config)# interface gigabitEthernet 0/1 Router(config-if)# ip address 192.168.2.1 255.255.255.0 Router(config-if)# no shutdown Use code with caution. Copied to clipboard Click on PC0 -> Desktop -> IP Configuration .