: If a thin part (like hair or a sword) is warped, dip it in hot water for 20 seconds, gently bend it into the correct shape, and hold it under cold water to set. 3. Assembly Sequence For complex figurines, follow this order:
If there are visible seams between parts, use a small amount of or UV resin . Once dry, sand it flush with the surface for a seamless look. VD-TGM0001.rar
: Start by connecting the largest central pieces. : If a thin part (like hair or
: Attach legs to the base (if applicable) and then the arms to the torso. VD-TGM0001.rar
: Use fine-grit sandpaper (400 to 1000 grit) to remove support marks or "seam lines" where the mold halves met. 2. Test Fitting (Dry Fit)